Avaya S8730 - Page 15

About server port connections
Installing and Configuring the Avaya S8700-Series Server January 2008
15
Figure 1: Duplication and control network cabling for hardware duplication (S8730)
Note:
Note: These are typical Ethernet port assignments. The customer might specify
different assignments for Eth0, Eth2, Eth3, and Eth4.
Figure notes:
1. Eth0 — CNA (also LAN for nondedicated control network)
2. Eth2 — Server duplication link - duplication crossover cable
3. Eth3 — To an Ethernet switch and/or the corporate LAN for control network B (CNB)
4. Eth4 — To the customer LAN if the control networks are dedicated
5. Fiber duplication cable
hw8730h2 LAO 082807
DAL1 DUP MEMORY
RECEIVE MODE
LINC SYNC
TRANS MODE
LINC ACTIVE
1
2
UID
ILO 2
PCIe 1PCIe 2
3
4
5
DAL1 DUP MEMORY
RECEIVE MODE
LINC SYNC
TRANS MODE
LINC ACTIVE
1
2
UID
ILO 2
PCIe 1PCIe 2
3
4
5
1
2
1
3
2
4
5