Avaya S8730 - Page 16

Chapter 1: Introduction
16 Installing and Configuring the Avaya S8700-Series Server January 2008
Figure 2: Duplication and control network cabling for hardware duplication (S8720/S8710)
Note:
Note: These are typical Ethernet port assignments. The customer might specify
different assignments for Eth0, Eth2, Eth3, and Eth4.
Figure notes:
1. Eth0 — To an Ethernet switch and/or the corporate LAN for control network A (CNA)
2. Eth2 — Server Duplication Link
3. Eth3 — To an Ethernet switch and/or the corporate LAN for control network B (CNB)
4. Eth4 — To the customer LAN if the control networks are dedicated
5. Fiber duplication cable
2
3
iLO
VDCI
DAL1 DUP MEMORY
RECEIVE MODE
LINC SYNC
TRANS MODE
LINC ACTIVE
1
2
3
133 MGz
100 MGz
100 MGz
UID
2 1
2
3
iLO
VDCI
DAL1 DUP MEMORY
RECEIVE MODE
LINC SYNC
TRANS MODE
LINC ACTIVE
1
2
3
133 MGz
100 MGz
100 MGz
UID
2 1
1
2
h3df87h2 LAO 122206
3
2
5
4
1