Avaya Scopia XT4300

To Next Page

To Previous Page

Figure 140: Enabling 1080p 60fps setting

2. Ensure that the 1080 60fps field is set to Yes.

3. From the web interface only, select Save.

Insufficient bandwidth

Solution

Make sure the network connection to the remote endpoint has enough bandwidth. Low bandwidth

conditions results in a reduction of resolution at the XT Codec Unit.

VISCA Cable

Solution

Make sure the VISCA cable is connected to the VISCA IN port of the camera. The VISCA cable is

part of the cable harness that connects the camera to the XT Codec Unit and is used to control the

camera. A common mistake is to connect this cable to VISCA OUT instead of VISCA IN. This

prevents the XT Codec Unit from setting the camera to the necessary resolution. For details, see

Connecting the PTZ Camera on page 49.

Avaya Scopia XT4300 - Page 189