09/09 Rev. 5.03-01 USER / SERVICE MANUAL Specifications
AP4.4 – AP5.4
5
Punch sensor Transmission sensor, adjustable from the left side about half of the material
width (0-60mm) [2].
Reflex sensor
• The reflex sensor for AP5.4 is optionally available (for reflex marks on the
material underside)
• Adjustable from the left side about half of the material width (6-66mm)
• The dark/light change at the reflex sensor is taken as the label beginning
(= end of the reflex mark)
[2] Measures and setting range of the punch / reflex mark.
Max. print length The maximum print length depends on the following:
• Printer type
• Printer resolution
• Firmware version
• Parameter settings (e.g. SYSTEM PARAMETERS > Free store size)
Zero line Offset of the material zero line to the print zero line: 1mm
Fonts
• 17 Fixsize fonts , including OCR-A and OCR-B
• 3 scalable fonts (Speedo fonts)
• Truetype fonts are supported
• Optionally can Truetype, Speedo and Fixsize fonts be stored on a CF-card
Modifying Fonts
• Up to factor 8 scaling in x/y direction
• Rotation by 0, 90, 180 and 270 degrees
Sensor type
Setting range
(Size c)
Punch length
(Size b)
Punch width
(Size a)
Transmission sensor
(Standard)
0–60mm 0,8–14mm min. 4 mm
Reflex-sensor
(optional)
6–66mm
4mm
(recommended)
12mm
(recommended)
[Tab. 3] Required punch measures.
a
b
c
Z0211.cdr
Punch / Reflex markPunch sensor Label web
To Next Page
Loading...
