Using Supplies 3-3
3. Feed all four inches of the backing paper under the applicator roller, over the peel bar, and
under the label deflector.
4. Push the label deflector up until it snaps into place.
5. Partially close the cover to the first position.
6. Pull enough backing paper over the guide roller to reach the pinch and feed rollers.
7. Hold the backing paper edge between the feed and pinch rollers and press the trigger.
Or, select Load Supply from the printer icon menu, then press the trigger.
8. Close the cover.
9. From the Load Supply menu, choose your supply type, and then select Calibrate.
Partially closed cover
Guide Roller
(behind supply)
Feed Roller
(behind Pinch Roller)
Pinch Roller
Applicator Roller
Peel Bar
Label Deflector
Pinch Roller
To Next Page
Loading...
