6-2 LNT Programmer’s Manual
290 Backfeed action is invalid.
291 Backfeed position is invalid.
292 Backfeed distance is invalid.
380 Job request is invalid.
401 Internal software failure.
409 The printer’s memory is full.
428 Invalid Batch or Graphic.
574 Check digit could not generate.
601 Failed to image.
614 The field is positioned off the label. This error is only reported when enabled. See
“
Enabling the ‘Field Off Tag’ Warning” for more information.
615 PDF417 mode is invalid.
616 The printhead has too many bad dots to print.
703 The printer sensed a calibration of different-sized black marks. Make sure the correct
supply is loaded.
704 Printer has not sensed a supply mark within the specified number of inches or out of
supplies.
706 The printer’s motor is jammed or encoder error.
750 Printhead is overheated. Turn off the printer to let the printhead cool. If the error
persists, call Technical Support.
751 Printer did not sense a black mark when expected. The supply may be jammed.
Reload supply. If the error continues to appear, call Technical Support.
752 Printer sensed a black mark in the wrong place.
753 Printer sensed a black mark that is too long.
755 Printhead is open.
756 The printer is out of supplies. Load supplies and/or clean the supply sensor.
758 Check supply. Either the supply is not seen, or the on-demand sensor is broken
(purchase optional). Check for a label jam. Clear the supply path or reload supplies.
762 The printer’s battery is low. Charge the battery.
765 The printhead has less than 3 bad dots.
766 Backfeed/overfeed error. There is a problem with the backfeed or overfeed distance.
768 Printhead has more than 8 bad dots or is not connected. Make sure the printhead is
connected.
790 The printer is busy. Turn off the printer. Wait two seconds and turn it back on. If the
problem continues, call Technical Support.
793 Printer job queue is full.
To Next Page
Loading...
