7821 User Instructions 19
5.4 Configuration Mode
5.4 Configuration Mode
The Configuration (CONF) Mode menu allows configuration of the scale to the specific
application need. The items you can configure are as follows:
Filtering (FILT)
Choose between FAST and SLO filtering. Slow should be chosen in areas susceptible
to vibration. Choose FAST filtering for more stable conditions.
Baud (BAUD)
Choose a baud and parity from table.
Protocol (PROT)
Select the communication protocol to be used on the RS-232 or USB VCP port. Only
one protocol & port can be used at a time.
NCI - Ref. 8408-14788-01
W, S, Z, H, U, M Only)
8213 - Ref. 8408-14788-03
3835 - Ref. 8408-14788-12
5.4.1 Step-by-Step Instructions for CONF Mode
Follow these steps to access and configure the items in the CONF menu. Refer to
Figure 5.2.
1. From the normal weighing mode, move Switch 1 to Menu Mode or OPEN
position, then press the ZERO key repeatedly until …
CONF is displayed.
2. Press the UNITS key …
FILT is displayed. This stands for filtering.
3. Press the UNITS key …
The current setting, FAST or SLO, is displayed.
4. Use the ZERO key to toggle between the two choices. Press the UNITS key
when the choice you want is displayed …
The choice is accepted and the display shows FILT.
5. Press the ZERO key …
BAUD is displayed.
6. Press the UNITS key …
The current baud and parity choice is displayed.
7. Use the ZERO key to scroll the choices found in Table 5.2. When the choice
you want is displayed, press the UNITS key …
The choice is accepted and the display shows BAUD.
To Next Page
Loading...
