Avid Technology Pro Tools MTRX - DADman Windows

Pro Tools | MTRX Studio Installation Guide6
Connecting Pro Tools | MTRX to the Network
Connect Pro Tools | MTRX to your network using either CAT5e or CAT6 cables connected to one or both
of the Ethernet ports on the back panel (see “Network Configuration” on page 4).
Depending on whether or not you have installed the optional Dante 64 module, and whether or not MTRX
is set to Switch mode or Redundant mode, make the following Ethernet connections:
• DADman control:
• Switch — Net 1 & 2
• Redundant — Net 1 only
• Dante 64 card:
• Switch — mirrored Dante Net 1 & 2
• Redundant — mirrored Dante Net 1 & 2
Connecting Pro Tools | MTRX to Pro Tools | HDX
You can use up to 64 channels of analog and digital I/O with MTRX connected to an HDX card using two
DigiLink Mini cables (not included).
To connect MTRX to an HDX card:
1 Required: Connect the first MTRX DigiLink Mini Port to DigiLink Mini Port 1 on the HDX card using
a DigiLink Mini cable (not included).
2 Optional: Connect the second MTRX DigiLink Mini Port to DigiLink Mini Port 2 on the HDX card us-
ing a second DigiLink Mini cable (not included).
+
Figure 1. MTRX connected to both DigiLink Mini ports on an HDX card
AES/EBU I/O 5-8
AES/EBU I/O 1-4 MADI
in
out
in
out
100-240VAC, 50/60 Hz
Max 90 VA
Fuse T1AH/250VAC
WC/VBB
PHD I/O
Primary 1 Pr 2/Exp
AES11 in
Net 1 Net 2
Optical I/O
8
75 1
1
2684