Pro Tools | MTRX Installation Guide40
Completing the Installation
After installing cards, reassemble the unit by replacing its top panel and then power on your system to con-
firm the installation.
To replace the top panel:
1 Replace the top panel, making sure to orient it correctly so that the tabs on its front edge fit under the unit
faceplate.
2 Using a #1 Phillips screwdriver, replace the 11 fasteners you removed earlier and secure the top panel
to the unit.
To confirm installation:
1 Make sure your switchable power source (power strip or other) is off.
2 Connect power to the MTRX using the included IEC power cable.
3 Switch on your power source.
4 Wait for the unit to initialize. Check the front panel display for status.
5 Power off the unit.
To Next Page
Loading...
