Appendix B: Installing MTRX Expansion Cards 35
3 If necessary, gently push down on the card until it clicks into its two retaining clips.
4 Proceed to “Completing the Installation” on page 40.
Installing a MTRX MADI Module
The MTRX MADI module is a daughter card that is mounted to the motherboard. Installing a MADI mod-
ule involves freeing the motherboard from the chassis, installing the MADI module onto its connector pins,
then reattaching the motherboard assembly to the chassis. In addition to a #1 Phillips screwdriver, you will
also need a small flathead screwdriver and a 3/16-inch socket or similar sized open end wrench.
Pushing the Dante card down into its retaining clips
MTRX MADI module, top (shown at left) and underside showing connector (at right)
To Next Page
Loading...
