Pro Tools | MTRX Installation Guide14
AD OL/Signal
Signal of AD channels 1–16. Yellow indicates signal input above –42 dB FS, and red indi-
cates signal level above –0.5 dB FS.
DA Signal/Carrier
Signal of DA channels 1–16. Yellow indicates signal input above –42 dB FS. Green in-
dicates signal below –42 dB FS and a valid digital input source/carrier.
Front Panel Status Display
The display of the MTRX has four rows for displaying information and four buttons for entering and scroll-
ing information. The display can show more pages and each page can consist of rows where settings can
be changed, and with rows for just showing status information. The display functions for the basic page are
described below. More pages are available depending on the firmware version of the MTRX. For more in-
formation on these pages, refer to the Pro Tools | MTRX Guide.
Operating Buttons
Setting
Pushing the Setting button scrolls trough the settings rows. The > cursor marks the selected
row/function.
Up
Pushing the Up button scrolls up the value/setting of the selected function.
Down
Pushing the Down button scrolls down the value/setting of the selected function.
Page
Pushing the Page button scrolls trough the available display pages.
Basic Display Page
(Sample Rate, Synchronization, ID, and Alarms)
Sample Rate
Shows the sample rate of the MTRX. If an asterisk * is shown, the sample rate is controlled
by an external digital audio interface.
Pro Tools | MTRX
PT HD1
Sample Rate
*
>
:
SRate Adapt
Sync Source
1:NameUnit
48
Intern
Sync OK
To Next Page
Loading...
