Introduction 1
Introduction
Welcome to the Avid S1 studio controller from Avid
®
. The S1 uses Avid’s high-speed EUCON
TM
(Extended User Control) protocol
to enable fully integrated control of Pro Tools
®
and other EUCON-compatible audio and video applications via an Ethernet con-
nection. Up to four S1s can be used simultaneously.
This guide shows how to install the S1 and EuControl software, and provides an overview of the control surface.
After installing the S1 control surface and EuControl software, see the Using EuControl Surfaces.pdf for instructions on how to use
S1 and other Avid media controllers to record, edit, and mix in Pro Tools. Thanks to the EUCON protocol, most steps for Pro Tools
are also applicable in other EUCON-aware applications from our development partners, including Logic Pro X, Cubase, Nuendo,
Pyramix and more (see the EUCON Application Setup.pdf to learn how to set up EuControl communication with these applica-
tions).
EuControl Software
EuControl lets your workstation computer find, link, and communicate with the S1 via the EUCON protocol.
EuControl also lets you set preferences for and customize the controls on your S1. EuControl software must be in-
stalled on the workstation computer before you can use the S1 with your application. You can also control applica-
tions on a secondary workstation computer by installing the separate EUCON Workstation software.
To Next Page
Loading...
Need help?
General
