600-00081-000 Rev 07
-27- FlightMax
Entegra PFD
When equiped with combined GPS/VHF navigator and Stec System
55X systems:
To perform an autopilot-coupled approach, ensure the approach
has been activated in the GPS selected as the Nav source. At that
point, press the NAV button on the autopilot control head to activate
Nav mode. Press the APR button on the Autopilot control head to
activate the glideslope capture capability. The autopilot will then
track the glideslope and localizer. Refer to the autopilot users guide
for glideslope capture scenarios.
It is recommended that the altitude bug be set to the published
approach decision height to serve as a visual reference during the
approach.
Precision Approaches Users Guide
For maximum situational awareness during all types of
precision and non-precision instrument approaches, always
select and activate the approach in the GPS/VHF navigator.
This will enable the Entegra PFD to display the approach
waypoints on its moving map.
Upon reaching the FAF, ensure that the correct baro is entered
in both the PFD and standby altimeter. Also verify that the PFD
and standby altimeter indicate the same altitude.
To Next Page
Loading...
