1. Use the mounting template to drill four mounting holes into the mounting surface.
2. Drill the cable entry hole into the mounting surface then pull the required cables through the cable
entry hole.
3. Fasten the mounting bracket or the junction box to the mounting surface.
Note: It is recommended that silicone sealant be applied around the edge of the mounting
bracket or junction box to prevent moisture from entering the mounting surface.
4. Insert the mounting hooks on the rear of the camera into the mounting hook slots on the mounting
bracket, then let the camera hang.
(Optional) Removing the Sun Shroud
The sun shroud should only be removed when the camera is installed indoors and space is limited.
1. As you press down on the center of the sun shroud, pull up the corners of the shroud from one side of
the camera.
2. Use a T20 Pin-In star-shaped driver to unscrew and remove the sun shroud mount from the camera.
(Optional) Removing the Sun Shroud 7
To Next Page
Loading...
