Reference: Configuration options
107
In this group of configuration options, you can define the status of the Allow privileged
option in the Network event window.
Always enabled
If this option is enabled, the Allow privileged option is enabled as the default setting in
the Network event window.
Always disabled
If this option is enabled, the Allow privileged option is disabled as the default setting in
the Network event window.
Remember last used state
If this option is enabled, the status of the Allow privileged option is handled in the same
way as for the previous network event in the Network event window: If the option Allow
privileged was enabled for execution of the last network event, the option is enabled by
default for the following network event. If the option Allow privileged was disabled for
execution of the last network event, the option is disabled by default for the following
network event.
13.5 WebGuard
The WebGuard section of the Configuration is responsible for the configuration of the
WebGuard.
13.5.1 Scan
WebGuard protects you against viruses or malware that reaches your computer from
web pages that you load on your web browser from the Internet. The Scan heading can be
used to set the behavior of the WebGuard component.
Scan
Enable Webguard
If this option is enabled, the web pages you request using an Internet browser are
scanned for viruses and malware. WebGuard monitors the data transferred from the
Internet using the HTTP protocol at ports 80, 8080, 3128. If any affected web pages are
detected, the loading of the web pages is blocked. If this option is disabled, the
WebGuard service is still started, but the scan for viruses and malware is disabled.
Note
The parental control function is independent of the enabling or disabling of the
WebGuard.
Drive-by protection
To Next Page
Loading...