Connections
• Power | Public Switched Telephone Network (PSTN) | Battery Management System (BMS) Relay
In/Out|USB Type B
Power Requirements/Protection
• 120v, 2.5A | Short Circuit, Overload, Over Voltage
Supervision
• Primary Power | Secondary Power | Telephone Line | Loop Monitoring
Operating Temperature
• Call Boxes: -13°F to 131°F (-25°C to 55°C)
• Call Commander: 23°F to 131°F (-5°C to 55°C)
• BOSS: 23°F to 131°F (-5°C to 55°C)
• For Indoor Use Only
Product Dimensions (W x H x D)
• BOSS: 17.20” x 12.59” x 3.46” (437 x 320 x 88mm)
• Call Commander: 7.95” x 9.84” x 2.91” (202 x 250 x 74mm)
• Surface Mount Call Box: 4.72” x 7.87” x 1.85” (120 x 200 x 47mm)
• Flush Mount Call Box: 5.11” x 8.66” x 3.62” (130 x 220 x 92mm)
Certications
• UL 2525
FCC Disclaimer
This device complies with Part 68 and Part 15 of the FCC rules. Operation subject to the following
two conditions:
(1) This device may not cause harmful interference and (2) This device must accept any
interference received, including interference that may cause undesired operation.
FCC Reg. No: AW7AL01A8055 Ringer Equiv:.01A
Telco Voltage
23-27vdc on a PBX line or 48-52vdc on an analog/digital line with at least 25mA of loop current and
valid dial tone. Line must be dedicated for the system.
Safety
• Do not expose to liquids or excessive humidity.
• Do not expose any of the components to re.
• Do not try to modify any of the equipment.
• Do not use the equipment in hazardous areas.
Maintenance
It is recommended for the system to be tested monthly to verify operation. If call boxes are in need
of cleaning, use a soft dry cloth. It is not recommended to use solvent or spray cleaners around the
speaker and microphone holes.
Specications
Page 22
To Next Page
Loading...