Page 13
17. In the message table, check the boxes next to all call stations that the message needs to be
uploaded to.
NOTE: If uploading messages for the rst time, make sure the rst six boxes are checked for
address information and operating instructions. Failure to do so may result in delays or an
inability to answer an emergency call.
18. To hear an audio sample of each line, click Click to Test. If the pronunciation of the text
needs to be modied, click on the call box that needs to be modied. Under Update Audio
on the right, type in the corrected text, then click Test. For proper pronunciation, the auto
may need to be typed out phonetically instead of using the accurate spelling to get the
desired pronunciation. Once proper text is determined, click Generate New to save. Repeat
for each line as necessary.
NOTE: Do NOT put any special characters in the Update Audio eld. Spelling must be done with
conventional letters.
19. After selecting all call stations, and adjusting audio if necessary, click the Upload button.
Uploading will take roughly two minutes per message. Wait until all messages upload before
clicking out of the message tab.
20. Once all conguration is complete, close out of the Conguration Software before testing by
clicking the “X” / Close icon in the top right corner.
Optional Programming
1. Open the Conguration Software following steps 1-6 in the System Programming section
on page 11.
2. Click Settings in the bottom left corner.
3. Next to time, the current system information will be displayed. Click Sync Time. This will
sync the system time with the PC. Verify time on the PC is correct before syncing with the
system.
System Time
System Fault
In the General Information tab under the Conguration menu there is the option for enabling
power and battery monitoring on the system. By default this feature is disabled. To enable and for
more information about fault monitoring, see page 17.
To Next Page
Loading...