Maintenance
18
AVL 415SE Smoke Meter — Maintenance Guide
this also concerns the inside parts of the shafts and rollers that can be
taken apart).
– Check the parts for wear and replace any affected components.
– Perform a complete cleaning of the device to clear any kind of contam-
ination present such as paper fibers, particulate matter or any other
system contamination.
4. After (every) approx. 100 / 300 (200) paper rolls:
– Check and, if required, replace the PU roller and the ratchet clip rollers
(if required, also the entire assembly including axles and rollers - see
Fig. 4 on page 22 - Pos. 110 to 150, or alternatively, replace the entire
ratchet clip).
– Perform all activities of step 3.
5. After approx. 1 000 paper rolls:
– Order an AVL service engineer: parts, such as the motor, camshaft
bearings, ratchet clip, clamping lever, suction unit or other worn-out
component parts, have to be checked by an AVL service engineer, who
will then decide if replacement is necessary.
NOTICE
The elastomer roller (Fig. 4 on page 22) on the ratchet clip cannot be cleaned.
This part has to be disassembled before cleaning the other mechanical parts or it
has to be replaced.
After cleaning of all parts they must be lubricated as shown in Fig. 1 to Fig. 4.
To Next Page
Loading...
Need help?
General
