31
Maintenance
AVL 415SE Smoke Meter — Maintenance Guide
3. Check that the camshaft is secured on the flattened part of the motor shaft if
the camshaft is replaced or was dismounted:
The setscrew in the camshaft must be screwed tight and secured
(ex-works: Loctite 245, Part Number HD0016).
4. Lubricate the bearing of camshaft in clamping lever using Teflon lubricant
spray (part number HS0058) or Teflon lubricant oil (part number HS0064),
or Lubricant grease OKS 260 (material number HS0071) - according to the
points indicate on Fig. 22 below.
2.3.9
Fine Filters
• Check the two fine filters every time the filter paper is exchanged.
– For normal operation:
We recommend replacing these two fine filters as soon as they
become blackened.
– When high hydrocarbon contents as oil and fuel occur in the exhaust:
We recommend replacing these two fine filters every time the filter
paper is exchanged.
Fig. 22 Lubricating points for camshaft, clamping piece and guides of paper transport roll
Camshaft
Lubricating
points
Lubricating points
Lubricating point
Lock nut
Setting nut
Taper hub washer
Clamping lever
Ratchet clip
Upper clamp piece
Clamping block
Lifting spring
Lower clamp piece
Reflectometer head cable
Reflectometer head
To Next Page
Loading...
Need help?
General
