SmartEdge Industrial IoT Gateway
User Guide
http://www.element14.com/gateway Page 32
STEPS REQUIRED
Find the IP addresses for the connected Gateway(s)
Read /DeviceID to get the device's serial number. You can use this to select the files needed for that device. If you
are unsure just issue the REST command to all IP addresses and if it responds then proceed with that Device ID.
Get the /WiFiIWList of in range WiFi access points. Then put /WiFiClientSSID_PSK to set the new
wpa_supplicant.conf file.
Issue the /IOTGetIOTConnectSDK command to get the current SDK configuration file. Modify the SDK configuration
file, then use the /IOTSetIOTConnectSDK to replace it.
Issue the /CloudAttach command to setup the WiFi connection, if configured. It will also start the SDK.
To Next Page
Loading...
