12 LongView 1000 Installer/User Guide
4. Select the color(s) you wish to adjust. You may adjust colors individually or as a group.
5. To increase the offset value of the selected color(s) by increments of one, press the Up key or
Plus key.
-or-
To decrease the offset value of the selected color(s) by increments of minus one, press the
Down key or Minus key.
If you are currently connected to a target device, the offset values will be immediately applied
to the video signal.
6. If you wish to save the current equalization tuning settings, click Save. The equalization tuning
settings will be permanently stored on the extender and will be applied to the video signal each
time you connect to a target device.
-or-
If you do not wish to save changes to the extender, click Close. The equalization tuning will
apply to the video signal of the currently connected target device until the connection is closed.
-or-
If you want to reset the equalization tuning values to zero and disable equalization tuning, click
Reset.
NOTE: If equalization tuning is not supported on your extender, you will not be able to access the Equalization
Tuning screen.
Deskew tuning
To adjust the video quality of the monitor connected to your user station, you may manually adjust
the deskew values that are applied during video compensation.
To edit deskew values:
1. Press the default Command Line hotkey sequence to display the Command Line.
2. Type deskew tuning and press Enter. The DeSkew Tuning screen will be displayed.
Figure 3.6: DeSkew Tuning Screen
3. Select Enable to allow manual adjustment of deskew values.
To Next Page
Loading...
Need help?
General
