Avocent LONGVIEW 1000 - Upgrading Your LongView 1000 R Receiver and Transmitter via Bootloader

Chapter 3: Operations 13
4. Select the color(s) you wish to adjust. You may adjust colors individually or as a group.
5. To increase the deskew value of the selected color(s) by increments of one, press the Up key or
Plus key.
-or-
To decrease the deskew value of the selected color(s) by increments of minus one, press the
Down key or Minus key.
If you are currently connected to a target device, the deskew values will be immediately
applied to the video signal.
6. If you wish to save the current deskew settings, click Save. The deskew settings will be
permanently stored on the extender and will be applied to the video signal each time you
connect to a target device.
-or-
If you do not wish to save changes to the extender, click Close. The deskew tuning will apply
to the video signal of the currently connected target device until the connection is closed.
-or-
If you want to reset the deskew values to zero and disable deskew tuning, click Reset.
NOTE: If deskew tuning is not supported on your extender, you will not be able to access the DeSkew
Tuning screen.
Upgrading Your LongView 1000R Receiver and Transmitter
via Bootloader
The LongView 1000 extender system can be upgraded through the serial port. All terminal
commands are accessed through a terminal or PC running HyperTerminal
®
emulation software
or equivalent.
To access the Terminal Applications menu:
Connect a terminal or PC running terminal emulation software to the serial port on the back panel
of the LongView 1000R receiver using a null modem cable. The terminal should be set to 57600
baud, 8 data bits, no parity, 1 stop bit and no flow control.