Chapter 3: Operations 19
Re-request Pod
The Re-request Pod feature allows an extender to attempt to regain access to a device if the user
station has no keyboard or mouse connected. When access is re-established to the target audio and
serial, access to the device is also re-established.
NOTE: The term “pod” refers to the data channel between a user station and the AMIQDM module.
To enable the Re-request Pod feature:
1. Activate the OSD by pressing the hotkey sequence. Ensure the Config tab is selected.
Figure 3.16: Configuration Menu (Re-request Pod Feature)
2. Click the Re-request Pod checkbox in the lower left-hand portion of the Configuration menu to
enable the Re-request Pod feature (disabled by default).
3. Click Close.
To Next Page
Loading...
