Chapter 3: Accessing the PM PDU via the Web Manager 15
been configured, Expert mode becomes the default mode. An administrator can toggle between
Expert and Wizard modes by clicking the tab bar on the Web Manager administrator screen.
Figure 3.2 shows a typical screen when an ad
ministrator is in Wizard mode.
Figure 3.2: Wizard screen
The following procedures describe how to configure the PM PDU from the Wizard.
To configure security parameters and select a Security Profile:
1. Select the Security link in the content
area.
2. Select the desired Security Profil
e. If using a Custom Security Profile, click the checkboxes
and enter values as needed to configure the services, SSH and HTTP and HTTPS options to
conform with your site security policy.
3. If you are not using DSView 3 software to manage the appliance, uncheck the Allo
w Appliance
to be Managed by DSView 3 box.
4. Click Next to
configure the Network or click the Network or Users link to open the appropriate
screen.
To configure network parameters:
1. Select the Network link in the
content area.
2. Enter the Hostname, Primary DNS and Domain in the appropriate
fields.
To Next Page
Loading...
Need help?
General
