Axis M1011 User Manual

AXIS M1011/M1011-W/M1031-W Installation Guide Page 17
ENGLISH
Resetting to the Factory Default Settings
This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power.
3. Keep the Control button pressed until the Power indicator flashes amber (this may take up to
15 seconds).
4. Release the Control button. When the Power indicator displays green (which can take up to 1
minute) the process is complete and the camera has been reset.
5. Re-assign the IP address, using one of the methods described in this document.
It is also possible to reset parameters to the original factory default settings via the web interface.
For more information, please see the online help or the user’s manual.
Accessing the camera from the Internet
Once installed, your AXIS M1011/M1011-W/M1031-W is accessible on your local network (LAN). To
access the camera from the Internet, network routers must be configured to allow incoming traffic,
which is usually done on a specific port
• HTTP port (default port 80) for viewing and configuration
• RTSP port (default port 554) for viewing H.264 video streams
Please refer to the documentation for your router for further instructions. For more information on
this and other topics, visit the Axis Support Web at www.axis.com/techsup
Further information
The user’s manual is available from the Axis Web site at www.axis.com or from the Axis Network
Video Product CD supplied with this product.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for the
AXIS M1011/M1011-W/M1031-W. To see the currently installed firmware version,
see Setup > About in the camera’s web pages.

Axis M1011 Specifications

General

Product color	White
Operating temperature (T-T)	0 - 50 °C

Weight and Dimensions

Weight	94 g
Dimensions (WxDxH)	58.9 x 94.9 x 34.2 mm