Axis M7001 Installation Guide

AXIS M7001 Installation Guide Page 5
ENGLISH
AXIS M7001 Video Encoder
Installation Guide
This installation guide provides instructions for installing a AXIS M7001 Video Encoder on your
network. For all other aspects of using the product, please see the product User’s Manual, available
on the CD included in this package, or from www.axis.com
Installation steps
Follow these steps to install the AXIS M7001 Video Encoder on your local network (LAN):
1. Check the package contents against the list below.
2. Hardware overview. See page page 6.
3. Install the hardware. See page 7.
4. Assign an IP address. See page 8.
5. Set the password. See page 11.
Package contents
If a covert camera was purchased together with the AXIS M7001 Video Encoder, the package
should also contain:
See Covert camera, on page 17 for more information.
Item Models/variants/notes
Video encoder AXIS M7001
Mounting kit • Metal bracket for wall/ceiling mounting
• 2 screws and plugs for concrete walls
• Terminal block connector (RS-485/422: 2x 2-pin connector)
CD Installation and Management Software CD
Printed materials AXIS M7001 Installation Guide (this document)
Item Models/variants/notes
Covert camera Analog camera
Mounting kit • Metal bracket for wall/ceiling mounting
• 2 screws and plugs for concrete walls
Important!
This product must be used in
compliance with local laws and
regulations.

Axis M7001 Specifications

General

Cable length	1.5 m

Weight and Dimensions

Weight	82 g
Dimensions (WxDxH)	37.4 x 101 x 30.1 mm