Axis Q1755 Installation Guide

Page 4 AXIS Q1755 Installation Guide
Hardware overview
!
IMPORTANT! - To use AXIS Q1755 outdoors, it must be installed in an approved
outdoor housing. Please see www.axis.com for more information on outdoor housings.
Part number (P/N) & Serial number (S/N).
The serial number may be required
during the installation.
Network indicator LED
Status indicator LED
Control button
Power connector
see page 12
Network
connector
see page 12
Power indicator LED
Audio out
Microphone
I/O connector
see page 12
RS-485/422
connector
Audio in
Video out
SD memory
card slot
Y/Pb/Pr/CVBS
CVBS
button
The camera is designed to be installed with the
Hole for wall/ceiling
stand
logotype facing down.

Axis Q1755 Specifications

General

Maximum resolution	1920 x 1080 pixels
Camera shutter speed	1/10000 - 1/2 s
Minimum illumination	2 lx
Sensor type	CMOS
Optical sensor size	1/3 \
Sample rate	16 kHz
Supported network protocols	IPv4/v6, HTTP, HTTPS, QoS Layer 3 DiffServ, FTP, SMTP, Bonjour, UPnP, SNMPv1/v2c/v3(MIB-II), DNS, DynDNS, NTP, RTSP, RTP, TCP, UDP, IGMP, RTCP, ICMP, DHCP, ARP, SOCKS, Pelco-D
Power source type	PoE
Power over Ethernet (PoE)	Yes
Power consumption (typical)	17.4 W
Ethernet LAN (RJ-45) ports	1
Dimensions (WxDxH)	186 x 85 x 211.4 mm
Power requirements	20 - 24 V AC
Certification	EN 55022 Class B, EN 61000-3-2, EN 61000-3-3, EN 55024, EN 61000-6-1, EN 61000-6-2, EN 60950-1, FCC Part 15, Subpart B, Class B, VCCI, Class B ITE, C-tick AS/NZS CISPR 22, ICES-003, Class B
Processor model	ARTPEC-3
Flash memory	256 MB
Internal memory	128 MB
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Weight	985 g