Specification
7
Code 103472
Model AT3086B
Rating Trade
Power 1.5kW 230V 1ph
Blade Speed 720m/min
Blade Length 3086.1mm
Blade Width Min/Max 3-19mm
Max Width of Cut 342mm without fence
Max Depth of Cut 356mm
Max Width of Cut with Fence 315mm
Noise Level 85dB
Table Size 552 x 410mm
Table Height 940mm
Wheel Diameter 355mm
Dust Extraction Outlet 100mm x 2
Overall L x W x H 740 x 825 x 1,921mm
Weight 145kg
Main Assembly
Your bandsaw is 95% assembled in order to reduce the
footprint of the machine for packaging, several items are
dismounted from the machine and need to be re-affixed.
WARNING! THE BANDSAW IS A HEAVY PIECE
OF MACHINERY, WE STRONGLY ADVISE YOU GET
THE ASSISTANCE OF ANOTHER PERSON OR USE
SOME SORT OF LIFTING DEVICE, (HOIST, ENGINE
CRANE), BEFORE YOU ATTEMPT TO LIFT OR MOVE
THIS MACHINE!
Mounting the Table
The saw table can be fitted without removing the blade.
However, if you would feel more comfortable not having to
manoeuvre the table around the blade (the table is quite
heavy), remove the blade by opening the top and bottom
covers, release the tension on the blade by releasing the
Quick release tensioning lever (A), see fig 01-02-03.
Remove the protective rapping around the bandsaw
blade, see fig B. CAUTION! take care, the blade is sharp.
Lift the bandsaw off the pallet using the ‘Eye Bolt Lifting Ring’
mounted to the top of the bandsaw. Place the saw on a flat
surface, ascertain the orientation of the machine and move it
to its desired position in the workshop. Ensure that the machine
is positioned to allow sufficient clearance all round to cater for
the maximum length of timber you wish to cut.
Fig 01-02-03
A
Continues Over....
B
Eye bolt lifting ring
To Next Page
Loading...
