24
AC504BiM OPERATION
Bluetooth
®
Operation
Most Bluetooth devices support the auto-connect feature, and will connect automatically
if the device is in range when the AC504BiM is powered-on. If your device was previously
paired but does not connect, use these instructions below. Some devices require
authorization to allow the auto connect feature.
• If your most recently connected Bluetooth device becomes disconnected or does not
reconnect, press from Bluetooth mode to reconnect your mobile device.
• To connect a previously paired device that was not recently connected:
1) If applicable, press and hold to disconnect any connected mobile devices.
2) From Bluetooth mode, press SELECT. "Paired Devices" will appear on the LCD.
3) Turn the volume knob to cycle through the list of devices.
4) Press SELECT or to connect to the desired device. It must be in range to connect.
Note: If the Auto Connect setup menu setting is set to OFF, you must press to
connect you device after pairing, and each time the AC504BiM is powered-on.
Press and hold
for 3 seconds to disconnect a connected device. The device will remain
paired and appear in the PAIRED DEVICES menu, but not be connected.
Before you can use a Bluetooth device, it must be paired and
connected. Make sure that Bluetooth is activated on your
device before you begin the pairing process.
The AC504BiM broadcasts the pairing signal constantly
when no devices are currently connected. Complete the
pairing sequence from your Bluetooth device. Refer to the
owner's manual for your device for more details.
The device name is "DUAL BT"
The Bluetooth passcode "1234"
Note: The AC504BiM can be in any mode of operation when
pairing is performed.
If a device is currently connected, press and hold to
disconnect the current device before a new device can
be paired. Then begin the pairing sequence from the new
Bluetooth device.
Pairing a Device
(Re)Connecting a Paired Device
Disconnecting a Device
Preparation
Pairing a New Device
Pairing Additional
Devices
To Next Page
Loading...
