Dual Assignment Instructions:
Note: Seek Up and Seek Down are initially set to
Preset Up and Preset Down for a long button press.
With the key in the accessory position. Press
and hold down the steering wheel button,
that you want to assign a long press function,
for roughly 10 seconds until the LED
flashes green rapidly. At this point release the
button and the LED will go solid green.
Press and release the Volume Up button the
number of times corresponding to the new
button number selected (refer to the chart in
the next column). The green LED will blink
rapidly when the Volume Up is pressed and
back to solid green when released. Then go to
the next step when the Volume Up button
has been pressed the desired number of
times.
Caution: If more than 10 seconds elapses
between a Volume Up button press this
procedure will abort, and the LED will go off.
To store the long press button in memory,
press the button that you assigned a long
press button (the button held down in Step 1).
The LED will now go off indicating it has been
stored.
Note: These steps must be repeated for each
button you would like to assign dual purpose
action to.
To reset a button, back to its original use,
repeat Step 1. Then press the Volume Down
button. The LED will go off and the long press
mapping for the button will be erased.
Dual Assignment Legend:
Button Press Button Action
1 Not Allowed
2 Not Allowed
3 Seek Up / Next
4 Seek Down / Next
5 Mode / Source
6 Mute
7 Preset Up
8 Preset Down
9 Power
10 Band
11 Play / Enter
12 PTT
13 On Hook
14 Off Hook
15 Fan Up
16 Fan Down
17 Temp Up
18 Temp Down
*Note: All Remapping and Dual Press features can be
done through the Axxess PC & Android app (Phones must
have hosting capabilities to configure AXSWC), or on
apple products using the AX-HUB. Visit
www.Axxessinterfaces.com to download, or Android
Playstore to download.
Harness Wire Locations:
To Next Page
Need help?
General
