GMOS-044
5
Notes
If your vehicle did not come equipped with OE steering wheel controls, you can
purchase an ASWCSTALK to retain both the clock setting function, and the ability
to change the personalization features in your vehicle. Below are the wiring
instructions on wiring and using the ASWCSTALK.
Note: The ASWCSTALK cannot be used to control the aftermarket radio,
i.e., volume, seek, mute, etc. You can only use the ASWCSTALK for controlling the
personalization menu.
1. Connect the two Black wires of the ASWCSTALK to 12-volt accessory power.
2. Connect the Green/Orange wire from the ASWCSTALK to the Green/Orange
wire on the 18-pin harness of the GMOS-044.
3. Tape up the Green/Black wire from ASWCSTALK, as it has no connection
in this application.
4. Turn on ignition and test the ASWCSTALK. The following are the buttons that
apply to this application. All other buttons will not be used in this application.
No OE Steering Wheel Controls
ENTER/SELECT EXIT UP DOWN
To Previous Page
Loading...
Need help?
General
