Installation instructions for part XSVI-6523-NAV
Axxess Integrate
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Can be used in both amplified and non-amplified models
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Pre-wired ASWC-1 harness (ASWC-1 sold separately)
• Retains the factory backup camera (if displayed through the OE radio)
• Retains the 3.5mm AUX-IN jack
• Retains balance and fade
• Micro “B” USB updatable
INTERFACE FEATURES
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
TOOLS REQUIRED
XSVI-6523-NAV
Chrysler Data Interface 2013-up
APPLICATIONS
• XSVI-6523-NAV interface • XSVI-6523-NAV harness
INTERFACE COMPONENTS
Connections to be made ................................................... 2
Installing the XSVI-6525-NAV .......................................... 3
Initializing the XSVI-6525-NAV ........................................ 3
TABLE OF CONTENTS
CHRYSLER
200 LX 2015-up
DODGE
Dart (small screen option)
2013-up
FIAT
500L 2014-up
500X 2016-up
JEEP
Cherokee Sport 2014-up
Renegade 2015-up
RAM
1500/2500/3500
(small screen option) 2013-up
Chassis Cab 3500/4500/5500
(small screen option) 2013-up
Promaster 2014-up
Promaster City 2015-up