9-12
Chapter 9 Maintenance and Inspection
(3) While pulling the lead wire from the hollow cable connection section at the lower
portion of the junction box, gradually put the sheath portion of the hollow cable in the
shell until it stops. Pay special attention so that the lead wire does not become caught.
Fig. 9-19. Assembling the hollow cable
(4) Tighten the hexagon gland at the top end of the hollow cable connection section to
secure the hollow cable.
(5) Connect the rubber tube to the hollow pipe and fitting for the hole of the rear cap
inside the junction box. Be sure to connect it securely.
Fig. 9-20. Connecting the rubber tube
Shell
Tube fitting
Rubber tube
Hexagon gland
Lead wire
To Next Page
Loading...