9-13
Chapter 9 Maintenance and Inspection
y
Assembling the Terminal Block Assembly and Hollow Cable
(1) Connect the lead wires of the hollow cable to the RED (+), BLK (-), and GND
terminals on the terminal block located on the board using screws.
Fig. 9-21. Connecting the hollow cable terminals
(2) Temporarily attach the two upper left and right screws of the four screws that hold the
terminal block assembly to the junction box.
(3) Push in the terminal block assembly all the way inside the junction box along the lower
right groove of the terminal block assembly so that the lead wire and hollow pipe are
not caught. At this time, slide and push the terminal block assembly up to the screws
that have been attached temporarily.
Fig. 9-22. Assembling the terminal block assembly
GND BLK (-) RED (+)
Slide.
To Next Page
Loading...