9-14
Chapter 9 Maintenance and Inspection
(4) Tighten the four screws, including the 2 temporarily attached ones, to secure the
terminal block assembly.
Tightening torque: 1.0 ± 0.1 N·m
Fig. 9-23. Attaching the terminal block assembly
y
Assembling the Optional Meter
If the meter has been removed, assemble it in the reverse of the disassembly order
(
l
Removing the Optional Meter (Page 9-10)).
(1) Connect the 2-wire cable wires (red, black) to the rear panel of the meter using screws.
Tightening torque: 1.0 ± 0.1 N·m
Fig. 9-24. Assembling the meter
To Next Page
Loading...