Azbil PTG60 - Handling Precautions

Azbil Corporation Installation
Model PTG60/70/71/72 - Smart Pressure Transmitter 2-11
Handling precautions
• 0RXQWLQJSURFHGXUH3LSLQJFRQGLWLRQVGL൵HUGHSHQGLQJRQWKHSURFHVV
/LTXLG0RXQWWKHQR]]OHRQWKHSLSHVLGHDQGLQVWDOOWKH7UDQVPLWWHUVLGHZD\V
away from the nozzle or below the nozzle so that no deposit is produced
and the gas generated returns to the process piping.
*DV 0RXQWWKHQR]]OHRQWRSRUWRWKHVLGHRIWKHSURFHVVSLSHDQGLQVWDOOWKH
Transmitter beside or above the nozzle so that the process returns to the
process piping.
6WHDP 0RXQWWKHQR]]OHLQWKHSLSHVLGHDQGLQVWDOOWKH7UDQVPLWWHUDWWKH
downside of the nozzle so that the condensed water collects in the conduit
piping.
• Weld or bind with a sealing tape securely to the piping joint to prevent a process
OHDNDJHIURPRFFXUULQJ
• Avoid installing the Transmitter with its front side facing down. Doing so invites
water, dirt and other sediment to deposit at the wetted part, causing an inaccurate
measurement.
• ,IWKHSURFHVVWHPSHUDWXUHH[FHHGV&)WDNHVRPHPHDVXUHVVXFKDV
installing a siphon, to defuse the high temperature at the wetted part so it does not
H[FHHG&)
• Install the Transmitter in a location where liquid process does not freeze.
2WKHUZLVHWDNHVRPHPHDVXUHVWRNHHSWKHSURFHVVÀXLGIURPIUHH]LQJ
• ,QVWDOOWKH7UDQVPLWWHULQDORFDWLRQZKHUHWKHUHLVQRH[FHVVLYHLPSDFWYLEUDWLRQ
RUSUHVVXUHVXFKDVZDWHUKDPPHULQJ
• After installing the transmitter, adjust the zero point.
)RUGHWDLOVRQWKHPHWKRGRI]HURSRLQWDGMXVWPHQWUHIHUWRFKDSWHU
³&DOLEUDWLRQ´