Azbil Corporation Calibration
Model PTG60/70/71/72 - Smart Pressure Transmitter 9-3
9-2 : Calibrating the set range by inputting the actual pressure
Overview
7KLVVHFWLRQGHVFULEHVKRZWRFDOLEUDWH859DQG/59IRUWKHVHWUDQJHE\LQSXWWLQJD
reference pressure into the Transmitter using the HART Communicator.
&DOLEUDWHWKH/59¿UVWDQGWKHQ859
Calibration devices
*HQHUDOO\WKHFDOLEUDWLRQGHYLFHVOLVWHGEHORZDUHUHTXLUHG
• 5HIHUHQFHSUHVVXUHJHQHUDWRU $JHQHUDWRUFDSDEOHRISURGXFLQJSUHVVXUHRYHU
a range of measurement close to that of the
transmitter to be tested.
• $FFXUDF\ )6RUZKLFKHYHULVODUJHU
• 3RZHUVXSSO\ 9'&
• 6WDQGDUGUHVLVWRU :
• 9ROWPHWHU 'LJLWDOYROWPHWHU9'&UDQJHZLWKDQ
DFFXUDF\RIUGJGJW
• HART Communicator
Requirements for calibration
CAUTION
When conducting the actual-pressure calibration, the following requirements must be
VDWLV¿HG
• The calibration must be conducted in a testing laboratory where there is no wind.
• 7KHVWDQGDUGWHPSHUDWXUHLV&^)`DQGWKHVWDQGDUGKXPLGLW\LV
5RRPWHPSHUDWXUHVIURP&^)`WR&^)`DQGURRPKXPLGLW\IURP
WRDUHDFFHSWDEOHDVORQJDVWKHUHVXOWRIPHDVXUHPHQWLVQRWLQÀXHQFHG
• It is best if the accuracy of the measuring instruments to be four times greater
than that of the Transmitter.