Azbil PTG60 - Page 48

Operation with Field Communication software (CFS100) Azbil Corporation
6-4 Model PTG60/70/71/72 - Smart Pressure Transmitter
online
l
DEVICE SETUP
l
DETAILED SETUP
l
Device Information
l
Manufacturer
l
Model
l
Measurement Type
l
Device ID *2
l
Tag
l
Date *2
l
Descriptor *2
l
Message *4
l
Sensor Serial Number *2
l
PROM ID
l
Final Assembly Number *2
l
Software Version *1
l
Revision Numbers *2
l
Universal Rev *2
l
Field Device Rev *2
l
Software Rev *2
l
Meter Type
l
Display Type
l
EU LO
l
EU HI
l
DE Conguration *1 *5
l
DE FS Mode *1 *5
l
DE Format *1 *5
l
DE PV type *1 *5
l
Switch Analog to DE
*1 *5 *6
l
Switch DE to Analog
*1 *5 *7
l
REVIEW
l
Model
l
Measurement Type
l
Manufacturer
l
Pressure Unit
l
PV URL
l
PV LRL *2
l
PV Damp
l
PV % Range
l
Transfer Function
l
PV URV
l
PV LRV
l
Analog Output *6
l
AO Alarm Type *2 *6
l
Fail Safe Direction *7
l
Sensor Serial Number *2
l
PROM ID
l
Device ID *2
l
Tag
l
Message *4
l
Software Version *1
l
Universal Rev *2
l
Field Device Rev *2
l
Software Rev *2
l
Poll Address *2
l
Num Req Preams *2
l
DE FS Mode *5 *7
l
DE Format *5 *7
l
DE PV type *5 *7
*1 Not displayed if HART communications is selected.
*2 Not displayed if SFN or DE communication is selected.
*3 Invalid menu in Field Communication Software Model CFS100.
*4 Not displayed if the transmitter version is one of the following: E.0, E.1
*5 Not displayed if the transmitter version is one of the following: E.0, E.1, E.2
*6 Not displayed if DE communication is selected.
*
7
Valid (displayed) if DE communication is selected.
Setting items and references
Task Parameter Section of
Manual
Preparation,
Adjustment"
Tag No., set or check Tag 2.2
Measurement range, check or change Basic Setup 2.5
Damping time constant, check or set Damping 2.6
Units of pressure, check or change Pressure Unit 2.4
Zero adjustment, execute Apply value 3.2
Loop test, execute Loop Test 3.1
Indicator, set Display 2.3
Maintenance Calibrate Correct Input 4.2