Azbil PTG60 - Page 61

Azbil Corporation Operation with Field Communication software (CFS100)
Model PTG60/70/71/72 - Smart Pressure Transmitter 6-17
Calibrated Value Reset
is operation is for resetting the calibrated zero-span value. Since the calibrated
value is deleted, you must recalibrate following the steps described in 4.2.
Select DEVICE SETUP o DIAG/SERVICE o Calibration o Correct Input o
Reset Corrects.
CAUTION: If this operation is performed while the pressure transmitter process is under
automatic control, outputs may fluctuate, making pressure transmitter
operation dangerous. Before performing this operation, make sure that you
switch the process control loop to manual control.
• 'RXEOHFOLFN5HVHW&RUUHFWV7KH³:$51/RRSVKRXOGEHUHPRYHGIURP
DXWRPDWLFFRQWURO´PHVVDJHLVGLVSOD\HGZDUQLQJWKDWWKHORRSVKRXOGEH
switched from automatic control to manual mode. After switching to manual
PRGHFOLFN2.
• 7KH³$ERXWWR5HVHWFRUUHFWV´PHVVDJHLVGLVSOD\HGWRQRWLI\\RXWKDW
FDOLEUDWHGYDOXHVZLOOEHUHVHW&OLFN2.
• $IWHUWKHFDOLEUDWHGYDOXHVDUHUHVHW³5HVHW&RUUHFWV2.´LVGLVSOD\HG&OLFN
2.
• 7KH³1RWH/RRSPD\EHUHWXUQHGWRDXWRPDWLFFRQWURO´PHVVDJHLV
GLVSOD\HGWRQRWLI\\RXWKDW\RXFDQQRZVZLWFKWKHORRSEDFNWRDXWRPDWLF
FRQWURO&OLFN2.