B. Braun Vista basic - Important Information on this Manual; Operational Guidelines and Safety; Checks after Repair

Important Information on this Manual
The following notes should be observed:
Service Work
Technical Safety Inspections
Current Versions
Revision Service
Non-Liability
Vista basic 950971 Rev A (5/04)
The present manual is for your information only. The possession of
this manual does not authorize the performance of service work,
Service tasks may only be executed by persons, who
- © have received appropriate training on the system from B.
Braun
- © areinctuded in the revision service
- © possess the necessary test equipment and mechanical aids,
and
- fulfil the personal requirements (training and knowledge).
B. Braun also recommends training on the technical safety in-
spections, or to perform at least the steps indicated in the current
version of the manual, as:
- the TS! requires that the instructions in the manuals are ob-
served
- the manuais are a reference for measurements
- depending on the unit type, the service program must be
called up which may leadto a dangerous unit conditionin the
case of an inappropriate operation. Furthermore, a special
service connector may be necessary.
This manual version corresponds to the state when the manual
was written. Technical changes, especially software modifications
must always be expected. The state of the revision is indicated by
the index number on the title page.
The possession of this manual does not automatically mean inclu-
sion in the revision service. You will be included in the revision
service after:
- technical training by B. Braun Melsungen or
- © a written order placed with the sales department of B. Braun
(incurred costs),
B. Braun Melsungen AG does not assume any responsibility for in-
juries to persons, property damages or other damages caused by:
- the use of a wrong manual, or a manual which does not cor-
respondtothe revision state for maintenance, repair, and ser-
vice tasks
- the non-inclusion of the service technician in the revision
service
- technicians who have not participated in a technical training
course for the specific B, Braun unit.