B2 HVA34 - 4.4 Operation Modes

4
Design and Construction
28
DHV0078 b2 EN
© b2 electronic GmbH
4.4 Operation modes
The following describes the scope of each HVA operation modes: test modes,
output modes, arc management modes and data transfer modes.
Test modes
The HVA can be operated in “manual” or “automatic” mode. For detailed
procedure, see 5.2 – Manual Test Mode, and 5.3 – Automatic Test Mode.
Test Mode
Characteristics
Manual
Designed to facilitate rapid testing. Test parameters of the
last manual test appear as the default setting.
• Test parameters can be changed immediately before
activating a test.
• Basic reporting most appropriate setting.
(Extended reporting will generate a report with most
fields left blank)
Automatic Designed for testing with predefined configuration in order
to satisfy specific requirements (e.g. IEEE, IEC
standards).
• Test sequence must be configured and saved at any
time before testing.
• Extended reporting most appropriate setting.