IS-033
___________________________________________________________________________
_______________________________________________________________________________________
Baader Ísland ehf, Hafnarbraut 25, Kopavogur, Iceland Tel: +354 520 6900 Fax: +354 520 6911
lager@baader.is / www.baader.is
38 Page 38
Knifes
To achieve the best possible results, knife edges should be sharp. The knife is to be verified
at regular intervals and be re-sharpened if required. It is necessary to remove the knife from
the machine for sharpening.
Knife Replacement.
Prior to working on the machine switch the main electrical switch to the 0 position
and lock it. Failure to comply may result in serious personal injury or death.
Danger wear protective gloves when handling knifes.
(Part no. 52100196 = 1 off; 2 are included in the tool set)
Knife nuts with left–handed threads are marked with
notches on the hexagon.
Using two 41mm spanners one on the
knife shaft and the other on the knife nut
slacken the M20 LEFT HAND THREAD
knife nut
Remove the knife nut.
It is now possible to remove the rotary
knife.
To Next Page
Loading...