Baader IS-033 - Safety Sensors

IS-033
___________________________________________________________________________
_______________________________________________________________________________________
Baader Ísland ehf, Hafnarbraut 25, Kopavogur, Iceland Tel: +354 520 6900 Fax: +354 520 6911
lager@baader.is / www.baader.is
7 Page 7
Safety sensors
Machines built from May 2012 have magnetic safety sensors as standard.
The sensors comprise two parts, (1) a magnet and (2) a
sensor, which need to be aligned for correct working. Please
refer to photograph A.
Failure of the magnetic safety sensors can be the result of:
 Opening and closing the guard too quickly;
 Opening and closing the guard only a short distance;
 Closing the guard with a slamming action;
To rectify this situation the following steps should be taken.
 Open the guard fully and close it in a controlled
manner;
 Turn off the power supply for 10 seconds and then
restore power;
 Machines built after November 2014. Depress the
top most button on the control unit for 3 seconds.
Please refer to the photograph B.
1
2
A
B