Screen 2
CLAMPS
Selection of clamp-holder unlocking option when the stringing is completed
LOCKED
⇒
Current selection. FREE: unlocked
HEAD
Selection of option Sensor head raising during traction cycle
YES
⇒
Current selection. Select YES or NO
>KNOT<
Setting of KNOT correction
+2.5 kg
⇒
Current value (default or last-used setting)
Direct modification by pitch of 100 g (0.5 lb) or by pitch of 1 kg (10 lb)
using scrolling keys
Over-tension range: 0 to 5 kg (0 to 11 lb)
>CROSS<
Setting of CROSS correction
-1.0 kg
⇒
Current value (default or last-used setting)
Direct modification by pitch of 100 g (0.5 lb) or by pitch of 1 kg (10 lb)
using scrolling keys
Range of over or under-tensions: -10 to +10 kg (-22 to +22 lb)
Screen 3
CONTRAST
Adjusting the contrast of the display
2....
⇒
Current selection. Possible selection from a range of 1 to 10
NB: this adjustment may cause the display to disappear. In this case
continue pressing to obtain a correct contrast.
BACK
Selection of Sensor head return function after clamp locking
HAND
⇒
Current selection. Select AUTO or HAND
ECO
Selection of energy-saving mode, deactivating clamp-holder after 15 minutes
(only on mono version)
YES
⇒
Current selection. Select YES or NO
>STRETCH<
Setting of prestretch
Modification expressed as a percentage of the tension value. Its purpose is to
create a prestretch at the beginning of the traction cylce to prevent the tension
being lost too quickly on certain types of string
15 %
⇒
Current value (last-used adjustment)
Direct modification by pitch of 1 % or pitch of 5 % (limited to 20 %)
using scrolling keys
22
To Next Page
Loading...
