Babolat SENSOR EXPERT - Troubleshooting Common Issues; Display and Arm Malfunctions; Clamp-Holder Malfunctions

TROUBLESHOOTING
At power up, the digital display does not light up
 Make sure the power cable is properly connected to the machine
and to a mains socket.
 Press the "cycle start" button:
- if the pulling arm moves, call your BABOLAT After-Sales
Service Centre,
- if the pulling arm does not move, check the fuses and replace
them if necessary (see paragraph "Changing voltage or
fuses").
At power up, the digital display lights up but no messages appear
 Press
shift
then several times (CONTRAST adjustment).
At power up, the digital display lights up but the pulling arm does not move
after the "cycle start" button is pressed
 Turn off the machine, wait 30 seconds and turn it back on.
 If the problem continues, go to screen 7 on the control panel.
Note down the values displayed on the DIAGNOSIS menu and the
serial number of the machine, then call your BABOLAT After-Sales
Service Centre.
During the stringing process, the clamp-holder malfunctions or does not
unlock
 Call your BABOLAT After-Sales Service Centre and if the problem
cannot be solved you will need to replace the circular turntable
(see paragraph "Replacing the circular turntable").
32