The measuring system on your SENSOR EXPERT stringing machine is
automatically adapted to the elasticity of the string (gut, synthetic, Kevlar
®
,
etc.).
The lifting system is fitted with a limiter that functions in the event of excessive
strain on the motor. This can happen with very rigid strings of the Kevlar
®
(or
polyester) type, which have a reduced lengthening capacity. The head rises then
falls back down after one second if the stress is excessive, regardless of the
position of the racket handle. You can overcome this drawback very easily by
leaving a centimetre of "slack" on the part of the string in traction.
Clamp-holding system
With the clamp-holder you can easily position
the 3-tooth clamp at any point on the racket by
sliding it over the circular turntable.
During the stringing process, in order to keep
the string pulled, you should:
- slide the clamp-holder over the turntable to
position it under the string that you wish to
keep pulled,
- tighten the string using the locking lever of
the 3-tooth clamp,
- the clamp-holder is automatically
immobilised on the turntable.
Mono version
: during the following traction, the clamp-holder is unlocked automatically
when the pulling head reaches 90 % of the required tension.
Loosen the string by lifting the locking lever then let the clamp drop. You can then move the
clamp-holder to immobilise the stretched string.
NB: the automatic clamp-holder unlocking function can be deactivated from the control
panel (see screen 2, CLAMPS menu).
♦ Removing the racket
Always start by loosening the billiards before opening the arms. After releasing the racket,
unscrew the billiards completely so that you can easily insert the next racket.
31
To Next Page
Loading...
