Babolat SENSOR EXPERT - Spring Tensioning Procedure

♦ Spring tensioning
Once the racket has been properly installed and the clamp(s) adjusted, refer to the stringing
recommendations of the racket manufacturer and enter the tension value of the string
(MAIN and CROSS correction) on the control panel.
 To tension the string, thread it through the
pulling unit. At this point you should make a
precise movement: bring the string towards
you, and without letting it go, lightly touch
the "cycle start" button. This precise
movement is something you should get used
to very quickly.
After the pulling head is activated, the pulling
unit closes itself over the string. Let go of the
string.
During the traction cycle, the digital display
indicates the actual value of the tension applied
to the string (from 0.0 kg up to the pre-set
tension value).
When the required tension is reached, use the 3-tooth clamp to maintain the tension of the
stretched string. Lightly touch the "cycle start" button again.
The pulling head will return to its initial position:
- automatically if the BACK function is in AUTO mode,
- by lightly touching the "cycle start" button if the BACK function is in HAND mode.
When the pulling head arrives at its end of travel without the tension being reached, the
buzzer goes off to indicate that the tension is not correct.
==BABOLAT== 22 JAN. 2000 18:35
___I___
0.0 kg - M - ..3..
MAIN CROSS TURNTABLE SPEED
30