♦ String measurer
The SENSOR EXPERT stringing machine has a system for measuring the length of the string.
If you wish to cut a string to a given length, make sure the control panel displays screen 1.
Then insert the end of the string into opening (A), above the On/Off switch, push in the
string and read the measurement (to the nearest 3 cm) on the control panel screen.
The measurement is taken when the end of the
string comes out of the opening to the left of the
tool bay. The measurement is bidirectional:
depending on whether the string is pushed or
pulled, the length increases or decreases.
Cut the string with pliers when the required
length is displayed. Then remove the string
from the measurer.
Return to screen 1 by pressing the
key
.
BE CAREFUL: never try to insert the string into the measurer by the opening on the left.
♦ Raising pulling head
With its self-raising head, the SENSOR EXPERT stringing machine functions automatically on
a perfectly horizontal plane at a constant height. This guarantees absolute precision and
total string performance, because there is no rubbing between string and racket.
The pulling head rises automatically when the "cycle start" button is pressed and until the
racket handle is presented. It drops automatically to let the racket handle pass through
when the turntable rotates.
NB: this function can be deactivated from the control panel (see screen 2, HEAD menu).
VERSION 01.01.P 22 JAN. 2000 18:35
STRING LENGTH : ----Xm
END RESET
29
To Next Page
Loading...
