Bacharach PCA3 - 4.15. Logging Selection; 4.16. Button Sound Selection

PCA

3 Manual
0024-9473 Rev 3 35
4.15. Logging Selection
When the logging function is activated, up to 500 combustion test records will be
automatically stored in memory at a preset interval over a predetermined length
of time.
Refer to Data Logging starting on page 54 for detailed information on how to
select the logging function, how to set the interval and duration time periods, and
how to view or download the stored data.
Figure 4-15. Logging Selection
4.16. Button Sound Selection
The audible sound used to signal when a button is pressed can be turned OFF
and ON as follows.
1. Display the MAIN MENU by pressing the MENU (F2) button. If
necessary, press ESC until MENU appears above F2.
2. Use the ▲▼ buttons to highlight SETUP, and then press ENT to display
the SETUP MENU.
3. Use the ▲▼ buttons to highlight BUTTON SOUND, and then press
ENT to display the BUTTON SOUND screen.
4. Use the ▲▼ buttons to highlight either OFF or ON. In the example
shown, OFF has been selected.
5. Press ENT to save the selection and re-display the SETUP MENU.
Figure 4-16. Button Sound Selection