WBPEEUI240756A0 Index - 1
Index
A
Address selection switch (S1) .................................... 3-3
B
Blinking green status LED .......................................... 5-3
C
Checking connections ................................................ 6-2
Circuit board cleaning................................................. 6-3
Cleaning printed circuit boards................................... 6-3
Communication levels ................................................ 1-2
Communication mode jumper (J2, J3)........................ 3-5
Communication mode jumper (J4) ............................. 3-5
Connector pin assignments, edge.............................. 5-4
D
Digital inputs, FSK (field bus mode)........................... 2-5
Dipswitch settings....................................................... 3-3
Documentation ........................................................... 8-1
E
Edge connector pin assignments ............................... 5-3
Error
Codes, smart transmitter ...................................... 5-2
Configuration mismatch........................................ 4-1
Corrective actions................................................. 5-1
I/O module missing............................................... 5-3
Messages ............................................................. 5-1
Transmitter not responding................................... 4-1
F
Factory test jumper (J2).............................................. 3-4
Firmware requirements............................................... 3-2
FSK digital inputs (field bus mode)............................. 2-5
Function codes 132 and 133...................................... 3-2
G
Glossary ..................................................................... 1-4
H
Handling ..................................................................... 3-1
Hazardous location installation................................... 3-2
I
Input jumpers (J6 - J20) ............................................. 3-5
Input jumpers (J6-J20)................................................3-5
Inspection....................................................................3-2
Installation
Field bus module...................................................3-6
Hazardous locations..............................................3-2
Termination module ..............................................3-5
Termination unit ....................................................3-5
Instruction ...................................................................1-4
Contents................................................................1-3
Glossary................................................................1-4
Intended user ........................................................1-1
Nomenclature........................................................1-6
Overview ...............................................................1-1
Reference documents...........................................1-5
Using.....................................................................1-4
J
Jumper settings
J2 ..........................................................................3-4
J3 ..........................................................................3-4
J4 ..........................................................................3-5
J6-J20 ...................................................................3-5
L
LED
Blinking green ................................................4-3, 5-4
Green ....................................................................4-3
Red........................................................................4-3
Status....................................................................4-3
M
Maintenance
Equipment required...............................................6-2
Overview ...............................................................6-1
Schedule ...............................................................6-1
Missing I/O module, error............................................5-3
Module
Application.............................................................1-2
Communication levels...........................................1-2
Description .....................................................1-1, 2-1
Error codes............................................................5-1
Features................................................................1-3
Operation ..............................................................2-1
Repair....................................................................7-1
Replacement.........................................................7-1
Specifications........................................................1-6
Status reports........................................................5-2
System operation ..................................................2-8
To Next Page
Loading...
